rahmat700 0 Report post Posted March 31, 2011 hello semua... sape pernah guna perisian orcad untuk lukis litar skematik n buat litar pcb, aku guna perisian ni tp kalau buat single layer mcm mane nak letak jumper secara automatik , sebab litar aku agak rumit, Quote Share this post Link to post Share on other sites
ztecon 5 Report post Posted April 6, 2011 assalammualaikum... ko kena wat skematik dulu baru leh wat layout PCB... btw ko student dari mana... Quote Share this post Link to post Share on other sites
rahmat700 0 Report post Posted April 6, 2011 aku da keje, aku dah siap skematik nye, pcb layout pun dah pernh buat tp double sided, kalau single side, ade yg takleh nak route,,, mcm mane nak letak [b]jumper[/b] di bahagian yang xdapat di route sbb litar terlalu komplek, aku nak letak jumpe secara automatik, bukan manual,, mcm mane ekh?,,, tolong ar Quote Share this post Link to post Share on other sites
