pali bote 0 Report post Posted September 26, 2008 hello..aku nak tny nie..kat umah aku ada modem RIGER DB102.modem nie ada router, bridge n modem. mcm mane nak setting supaya leh wat autoconnect? aku dah try wat mmg jadi..pastu after 2 hr aku wat dia kuar limited..sedangkan aku dah masukkan IP ADDRESS.so macam mane nak bg dia leh sampai bile2 ok??aku dah wat mcm kali dah..lepas aku set aku dah wat commit n reboot..tolong aku k..aku gune pakej combo 1 rm60 384 kbps.. Quote Share this post Link to post Share on other sites
penyu_hijau 0 Report post Posted October 14, 2008 hello..aku nak tny nie..kat umah aku ada modem RIGER DB102.modem nie ada router, bridge n modem. mcm mane nak setting supaya leh wat autoconnect? aku dah try wat mmg jadi..pastu after 2 hr aku wat dia kuar limited..sedangkan aku dah masukkan IP ADDRESS.so macam mane nak bg dia leh sampai bile2 ok??aku dah wat mcm kali dah..lepas aku set aku dah wat commit n reboot..tolong aku k..aku gune pakej combo 1 rm60 384 kbps..Riger DB102Go to http://192.168.1.1.Username: tmadmin Password: tmadmin Then you will see this above page. Go and click at the WAN Tab and click at PPP.Set the new interface as:PPP interface = 0 ATM VC = aal5-0 Protocol = PPoE Use DNS = enable Security = PAP Don’t forget to set your username as username@streamyx and also your TMNet Streamyx password. When done, click Submit.Click on ATM VC and make sure interface are set as:aal5-0 VPI = 0 VCI = 35 MUX = LLC Max proto = 2 After that, click on Admin and then Commit and then Reboot Once it’s done you should check your Internet connectivity by loading your favorite website.If you’re unable to go to 192.168.1.1, please make sure that your PC IP is in the range of 192.168.x.x.Done! Quote Share this post Link to post Share on other sites