gorgon 0 Report post Posted December 28, 2004 aku dah lame pakai mobo NF7s dgn RAM 512mb (256x2) DDR 400. apsal ar mobo aku tulis DDR 333 masa start pc (aku x pandai komputer), kenape x detect 400? aku dah pernah flash bios skali (tah version bape, tp ade tulis utk detect dual cenel). kene set kat bios ke? bape speed die.. bape karen die nak.. tolong la aku wahai rakan2.. 1234, ajar aku cepat2 (iklan kasut).. Share this post Link to post Share on other sites
Hoodlums 0 Report post Posted December 28, 2004 Ko kena masuk BIOS pegi kat SoftMenu...FSB : DRAM Ratio set By SPD...Default ialah Auto.. Share this post Link to post Share on other sites
arfaie 15 Report post Posted December 28, 2004 DDR 400 kan? maybe ko guna board yg version lama, 1.0.. board nie tak support DDR400... version 1.1 ngan 2.0 jer officially support Share this post Link to post Share on other sites
Hoodlums 0 Report post Posted December 28, 2004 Try setting kat BIOS dulu.. Share this post Link to post Share on other sites
sauron 0 Report post Posted December 28, 2004 mungkin dia detect ikut speed proc ko kot....sbb tu dia bace 333mhz Share this post Link to post Share on other sites
smile4me 1 Report post Posted December 29, 2004 tu sume bole ubah dlm BIOS.. Share this post Link to post Share on other sites
Hoodlums 0 Report post Posted December 29, 2004 Si gorgon ni guna Sempron atau Barton laa nihh..System Bus Barton @ Sempron 333Mhz, default setting kat BIOS NF7s utk FSB : DRAM ialah Auto...Speed RAM akan ikut speed System Bus, sebab tu laa detect DDR333....Utk dapatkan nilai DDR400 mudah jerk, tukar setting FSB : DRAM kepada "By SPD"....Try laa... Share this post Link to post Share on other sites
gorgon 0 Report post Posted December 29, 2004 oooo.. dulu aku beli mase awal keluaran.. lagipon aku gune barton 2500.. ok la.. tutup topik.. paham2.. thanx Share this post Link to post Share on other sites
