Jump to content
Sign in to follow this  
emyrul

Printer Port Usb Tak Boleh Detect

Recommended Posts

kepada otai-otai mintak tolong bagi solution pasal masalah ni. Printer ni gune usb cable. Masa kite cucuk kat usb port, keluar msg 'Usb Device not recognized'.

Kalau nak install secara manual, port usb printer tak de. mintak tolong nye

Share this post


Link to post
Share on other sites

cuba check di BIOS...sama fungsi USB sudah enable atau belum....USB anda memerlukan power yang lebih untuk beroperasi.... kalau mobo anda jenis lama, mungkin BIOS anda tidak support....kalau jenis lama sila update BIOS......try juga disable parallel port jika tidak digunakan....CD driver untuk printer itu sudah di install atau belum?

Share this post


Link to post
Share on other sites

kat bios dah enabled, pen drive boleh baca tapi bile cucuk kabel printer keluar msg tu. cd dah masuk tapi masa nak install driver, printer tak detect. mobo jenis msi baru je beli lam sebulan. jenis printer canon pixma ip3000

Share this post


Link to post
Share on other sites
Tukar usb cable..., aku penah kene kes mcm ni.. Edited by Yem

Share this post


Link to post
Share on other sites

kat bios dah enabled, pen drive boleh baca tapi bile cucuk kabel printer keluar msg tu. cd dah masuk tapi masa nak install driver, printer tak detect. mobo jenis msi baru je beli lam sebulan. jenis printer canon pixma ip3000

usb kau tu boleh pakai tak?...test dengan benda lain dulu...klu printer canon kau kena tukar port usb tu, masa dia nak connet dgn printer...sbg cth lah kau pakai port usb 1 pastu masa dia kata cari tak jumpa tu kau pun cabut kat port tu dan msk kat port lain.pasti boleh.... laugh.gif itulah masalah canon.. dry.gif

Share this post


Link to post
Share on other sites

Askm Semua kawan. saya rasa kabel USB printer tu yang rosak. Elok ganti yang baru. Biasanya kepala kabel tu sudah haus ( lus ) dan longgar ( dah tak ketat ). Jangan salahkan komputer pulak kesian komputer tu. Sekian

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...